Configuring Ntp Operating Modes - Huawei AR530 Series Configuration Manual

Huawei AR530&AR550 Series Industrial Switch Routers
Configuration Guide - Device Management
Figure 4-10 NTP synchronization subnet
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
ntp-service refclock-master [ ip-address ] [ stratum ]
The local clock is configured as the NTP primary clock.
By default, no NTP primary clock is specified.
----End

4.5.1.2 Configuring NTP Operating Modes

Context
The following NTP operating modes are supported by a device:
Issue 01 (2014-11-30)
RouterB
Stratum2
RouterC
Stratum3
NOTE
After the local clock is configured as the reference clock, the local device can be used as the clock source
to synchronize other devices on the network. Confirm before this configuration, so as avoid clock errors
on the network.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
RouterA
Stratum1
4 NTP Configuration
Synchronization direction
71