Adjusting Coolant Flow - Sharp SW-100T Instruction Manual

When cutting irregularly-shaped material, if possible, avoid positioning the work in the way that the cut
would be started on a sharp corner. Arrange your workpiece in the way that as many teeth as possible
will be applied to the work at one time.

Adjusting Coolant Flow

Step 1 – Press the power on button to start the saw blade drive motor.
Step 2 – Lower the saw bow.
Step 3 – Use the flow control valve (shown below) to adjust the amount of fluid flowing to the cutting
area.
Adjust the flow amount if you observe the following changes to the chips generated from cutting.
If the chips are sharp and curved, increase the coolant
flow amount.
If the chips are granulated, decrease the coolant flow
amount.