Adjusting Horizontal Stop Spring Cushion - Sharp SW-100T Instruction Manual

Step 2 – After adjustment is made, tighten the blade guide locking handle.
Locking Handle

ADJUSTING HORIZONTAL STOP SPRING CUSHION

Always make sure the power cord is disconnected from power source when making adjustments.
Complete Cut – Adjusting Horizontal Stop Spring Cushion
The workpiece should be able to cut through completely. If it does not, please follow these steps to adjust
the horizontal stop spring cushion.
Step 1 - Place a level on the workbed (Fig 10, #4)
to make sure the bed is level.
Step 2 - Loosen the lock nut (Fig 10, #3) and
lower down the saw bow. Place the
level on top of the saw blade (Fig 10-A)
to check its leveling against the bed
horizontal line. Adjust the screw (Fig 10,
#2) until the blade is level.
Step 3 - Tighten the lock nut (Fig 10, #3) when
leveling is obtained.
If the saw blade top line is not leveled
against the bed horizontal line, the workpiece
will not be able to cut off completely.