ADJUSTING SAW ARM
Adjust the blade guide (guide arm) position based on the size of your workpiece:
While adjusting the guide arm, be careful not to hit the vise.
Step 1 – Loosen the blade guide locking handle. Then adjust the guide arm to a position suitable for
your workpiece size. Move the right blade guide according to the label for miter cutting.
Step 2 – After adjustment is made, tighten the blade guide locking handle.
Locking
Handle
ADJUSTING COOLANT FLOW
Step 1 – Press the saw blade start button to start the saw blade drive motor.
Step 2 – Use the flow control valve (shown below) to adjust the amount of fluid flowing to the cutting
area.
Flow Control Valve
handle
Adjust the flow amount if you observe the following changes to the chips generated from
cutting.
If the chips are sharp and curved, increase the coolant
flow amount.
If the chips are granulated, decrease the coolant flow
amount.
4-11