Cutting Operation; Selecting Blade Speed; Changing Blade Speed - 4 Speed Step Pulley - Sharp SW-100T Instruction Manual

CUTTING OPERATIONS
Do not connect power cord to power source until the following instructions are clearly
understood and followed.

Selecting Blade Speed

Blade speed selection should be made according to the material being cut. The following chart provides
information on blade speed and is used for reference only.
Material
High speed alloy, stainless and
heavy cross section material
Tool, stainless and alloy steel,
bearing bronze
Cast iron, mild steel, hard brass,
bronze
Plastic, copper, soft brass,
aluminum, other light materials
Some materials due to manufacturing processes such as certain types of cast iron pipe or
materials containing certain types of welds cannot be cut on the machine.
Changing Blade Speed – 4 Speed Step Pulley
50 Hz
(Fig 1)
Speed
60 Hz
57 68
100 120
164 196
277 330
Step 1 - Remove pulley cover.
Step 2 - Loosen lock handle.
Step 3 - Position belt in proper grooves
according to below speed selection chart
attached on the pulley cover.
Step 4 - Make sure the belt is tightly and
securely positioned in the groove and
tighten lock handle.
Step 5 - Install pulley cover back in place.
Pulley Groove Used
Motor pulley Saw Pulley
Smallest
Small Medium
Medium
Large Smallest
Large
Small