Installing Roller Table (Optional); Installing Fire Control Device; Relocating - Sharp SW-100T Instruction Manual

Installing roller table (optional)

The roller table is used to support long material at
the rear and/or the front of the machine.
If you have ordered the optional roller table for
cutting long material, position it before or behind
the machine.
Level the roller table and the stand with the
machine by adjusting the leveling bolts.

Installing fire control device

Install a fire extinguisher or any other fire control device in the shop in case a fire breaks out.

RELOCATING

We recommend you follow these procedures when relocating or shipping your machine to other place:
1. Descend the saw frame to its lowest position then turn off the power.
2. Fix the saw frame using the shipping bracket that originally came with the machine.
3. If you are shipping the machine, pack the machine carefully with industrial plastic wraps to
protect it from dust.
4. Use a crane or forklift to raise it. If a crane is used to lift the machine, ensure that the lifting cable
is properly attached to the machine.
5. Do not forget to include the equipments originally furnished including the shock absorption steel
plates and the instruction manual.
Adjust bolts