Removing Shipping Bracket; Cleaning; Installing; Supplying Hydraulic Oil - Sharp SW-100T Instruction Manual

REMOVING SHIPPING BRACKET


After the machine has been properly
positioned, remove the shipping bracket that is
used to lock the saw frame and the saw bed.

Retain this bracket so that it can be used again
in the event that your machine must be
relocated.

CLEANING

After the machine has been placed at the designated position, remove the rust-preventive grease with
wiping cloth dampened with cleaning oil or kerosene. Apply machine oil to machine surfaces that are
prone to rust.
Do not remove the rust-preventive grease with a metal scraper and do not wipe the
painted surfaces with solvent as doing so would damage surface paint.

INSTALLING

Our bandsaw machine is relatively easy to install. Follow these six easy steps to install your machine.
Supply
hydraulic oil

Supplying hydraulic oil

Open the filler cap and fill the hydraulic oil tank to
above 2/3 or full level.
Check the sight gauge to make sure the oil level in
the tank.
Refer to specification chart under Section 2
for tank capacity.
Oil tank should be full already if it is a new
machine that operates for the first time.
Supply
cutting fluid
Connect
Leveling &
electric
anchoring
power
Installing roller
table
(Optional)