Vise Loading - Sharp SW-100T Instruction Manual

4. Tooth pitch
The main factor here is the contact length of the blade in the workpiece.
If it is 4P, 25.4 ÷ 4 P = 6.35 mm, that is, one tooth is 6.35 mm.
If it is 3P, 25.4 ÷ 3 P = 8.46 mm If the number is small, it means that the tooth is large.
What is written as 3/4 is that it is a variable pitch of large (3) / small (4).
The saw blade must contact the cutting material at least two pitches. In the case of a thickness of 15 mm,
4P = OK, 3P = NG.

The surface conditions will also affect the cutting rate. If there are places on the surface on the
material which are hard, a slower blade speed will be required or blade damage may result.

It will be slower to cut tubing than to cut solids, because the blade must enter the material
twice, and because coolant will not follow the blade as well.

Tough or abrasive materials are much harder to cut than their machinability rating would
indicate.

Tooth spacing is determined by the hardness of the material and its thickness in cross section.

Tooth set prevents the blade from binding in the cut. It may be either a "regular set" (also
called a "raker set" ) or a "wavy set".

The regular or raker set is most common and consists of a pattern of one tooth to the left, one
tooth to the right, and one which is straight, or unset. This type of set is generally used where
the material to be cut is uniform in size and for contour cutting.

Wavy set has groups of teeth set alternately to right and left, forming a wave-like pattern. This
reduces the stress on each individual tooth, making it suitable for cutting thin material or a
variety of materials where blade changing is impractical. Wavy set is often used where tooth
breakage is a problem. This is shown in Fig. 7.2 as follows:
Regular (raker) Set

VISE LOADING

The position in which material is placed in the vise can have a significant impact on the cost per cut.
Often, loading smaller bundles can mean greater sawing efficiency.
Straight
Fig. 7.2 The Saw Set
When it comes to cutting odd-shaped material, such as angles, I-beams,
channel, and tubing, the main point is to arrange the materials in such a way
that the blade cuts through as uniform a width as possible throughout the
entire distance of cut.
Right
Left
Wavy Set