Emergency Stop - Sharp SW-100T Instruction Manual

Safety Related Switches
To protect the operator, the following safety related switches on the machine are actuated when the
machine is in operation.
Wheel motion detector
Power switch
Emergency stop button
Vise clamp switch
Wheel cover interlock switches
(CE model only)
Among all these safety switches, some of them are used to protect the users and some of them are used
to prevent damage to saw blades, the workpiece and the machine itself, etc. We have taken every
precaution to prevent injury or damage and to provide safe and economical operation of the machine.

EMERGENCY STOP

Designed to be easily accessible, the emergency stop button is located on the left bottom corner on the
control panel and is made in red color and rubber material.
stop button may be available at other area(s) of the machine depending on machine type. Please refer
to Illustration: Emergency Stop.
When you press the button, the machine will immediately come to a full stop to avoid injury or damage
when an accident occurs. The button will be locked when you press it. To unlock it, turn the button
clockwise.
You should press it immediately without any hesitation when observing:

An emergency situation that would cause any injury or damage

An abnormal situation or problem such as fire, smoke, abnormal noise and etc.
This is a proximity sensor used to detect the motion
of the drive wheel. Once the saw blade is broken
as soon as it starts slipping, the sensor will detect
and stop the drive wheel and the machine.
Located on the cover of electrical cabinet, the power
switch controls the main power of the machine.
to your company's internal rules, this power switch
can be locked with a padlock or a luggage lock to
protect the operator and the machine.
Located on the control
pressed will stop the machine completely.
This switch assures firm clamping of the workpiece. If
the workpiece is not clamped properly, the saw blade
is not allowed to run.
Located on the two wheel housings, these switches
are used to assure that the machine will stop
whenever the wheel covers are open. This device is
to protect users from being cut by the running saw
blades.
panel, the button when
For CE models, supplementary emergency
or
Up