Snmp User - TP-Link T2500G-10TS User Manual

Note:
Every Group should contain a Read View. The default Read View is viewDefault.

13.1.4 SNMP User

The User in an SNMP Group can manage the switch via the management station software. The
User and its Group have the same security level and access right. You can configure the SNMP
User on this page.
Choose the menu SNMP→SNMP Config→SNMP User to load the following page.
The following entries are displayed on this screen:
User Config

User Name:
User Type:
Group Name:
Security Model:
Security Level:
the Modify button to apply.
Figure 13-6 SNMP User
Enter the User Name here.
Select the type for the User.
Local User: Indicates that the user is connected to a
•
local SNMP engine.
Remote User: Indicates that the user is connected to a
•
remote SNMP engine.
Select the Group Name of the User. The User is classified
to the corresponding Group according to its Group Name,
Security Model and Security Level.
Select the Security Model for the User.
Select the Security Level for the SNMP v3 User.
230