Connecting The Bcm To The Network; Registering Ip Terminals - Avaya BCM450 Rls 6.0 Task Based Manual

Hide thumbs Also See for BCM450 Rls 6.0:

Table of Contents

BCM450 System Start Up

Connecting the BCM to the Network

NOTE: If the BCM is in a Standalone Installation, this section should be

ignored.

After the BCM has been prepared for the network, and the preceding

initialisation procedures have been performed, the BCM can be connected to

a Local Area Network (LAN).

Plug one end of a standard RJ45 patch cable into one of the LAN ports

of the BCM. Plug the other end of the cable into a network connection

point, e.g. a wall mounted RJ45 socket, or directly into a switch/hub.

The following procedure describes how to configure the BCM to allow IP

Telephones to register on the BCM.

Note: For full instructions on how to register and set up IP terminals, including

Remote worker sets, refer to the IP Telephony Guide.

1. From the Configuration tab, open the Resources folder to expand it.

2. Select Telephony Resources from the Resources folder.

3. Select IP Sets from the Configured Device column. The Details for

Module displays in the lower pane with the IP Terminal Global

Settings tab as the default.

NN40010-317 Issue 1.2 BCM450 Rls 6.0

Table of Contents