D-Link DAP-2660 User Manual page 43

D-Link DAP-2660 User Manual
User Limit (0-64):
Enter the maximum amount of users that are allowed access (0 to 64 users) to the device using the specified wireless
band. The default setting is 20.
11n Prefered: Use the drop-down menu to Enable or Disable the 11n Preferred function. The wireless clients with 802.11n protocol
will have higher priority to connect to the device.
Network Utilization:
Set the maximum utilization of this access point for service. The DAP-2660 will not allow any new clients to associate
with the AP if the utilization exceeds the value the user specifies. Select a utilization percentage between 100%, 80%,
60%, 40%, 20%, or 0%. When this network utilization threshold is reached, the device will pause one minute to allow
network congestion to dissipate.
Aging Out: Use the drop-down menu to select the criteria of disconnecting the wireless clients. Available options are RSSI and
Data Rate.
RSSI Threshold: When RSSI is selected in the Aging Out drop-down menu, select the percentage of RSSI here. When the RSSI of
wireless clients is lower than the specified percentage, the device disconnects the wireless clients.
Data Rate Threshold: When Data Rate is selected in the Aging Out drop-down menu, select the threshold of data rate here. When the data
rate of wireless clients is lower than the specified number, the device disconnects the wireless clients.
ACL RSSI: Select to Enable or Disable the ACL RSSI feature here. When enabled, the device denies the connection request from
the wireless clients with the RSSI lower than the specified threshold below.
ACL RSSI Threshold:
Set the ACL RSSI threshold percentage.
43