D-Link DAP-2660 User Manual page 39
Airpremier wireless ac1200 concurrent dual band poe access point
Hide thumbs
Also See for DAP-2660:
- User manual (89 pages) ,
- Quick installation manual (49 pages) ,
- Manual to install the firmware (5 pages)
Table of Contents
Advertisement
D-Link DAP-2660 User Manual
WMM (Wi-Fi
WMM stands for Wi-Fi Multimedia. Enabling this feature will improve the user experience for audio and video applications over
Multimedia):
a Wi-Fi network. This feature is enabled by default and can only be disabled when Mixed 802.11g and 802.1b was selected
as the Wireless Mode.
Ack Time Out
To effectively optimize throughput over long distance links enter a value for Acknowledgement Time Out between 48 and 200
(2.4 GHZ, 48~200):
microseconds for 2.4 GHz in the field provided.
Short GI:
Select Enable or Disable. Enabling a short Guard Interval (GI) can increase throughput. However, be aware that it can also
increase the error rate in some installations due to increased sensitivity to radio-frequency installations. This option cannot be
enabled when Mixed 802.11g and 802.11b was selected as the Wireless Mode.
IGMP Snooping:
Select Enable or Disable. Internet Group Management Protocol (IGMP) allows the AP to recognize IGMP queries and reports
sent between routers and an IGMP host (wireless STA). When IGMP snooping is enabled, the AP will forward multicast packets
to an IGMP host based on IGMP messages passing through the AP.
Multicast Rate:
Select the multicast packet data rate value here. Options to choose from are 54, 48, 36, 24, 18, 12, 11, 9, 6, 5.5, 2 and 1
Mbps. The multicast rate is supported in AP mode, (2.4 GHZ and 5 GHZ) and WDS with AP mode, including Multi-SSIDs. This
option cannot be configured when 802.11n Only was selected as the Wireless Mode.
Multicast Bandwidth
Select to Enable or Disable the multicast bandwidth control option here.
Control :
Maximum Multicast
After enabling the multicast bandwidth control option, enter the maximum multcast bandwidth value here. By default this
Bandwidth:
value is 100 Kbps.
HT20/40 Coexistence :
Enable this option to reduce interference from other wireless networks in your area. If the channel width is operating at 40MHz
and there is another wireless network's channel over-lapping and causing interference, the Access Point will automatically
change to 20MHz
39
Advertisement
Table of Contents
