Filler Plate; T1/E1 And Ethernet Ports; Figure 11 Module Slot; Figure 12 Filler Plate - Alcatel-Lucent 7705 Installation Manual

7705 SAR-M Components
For additional information on modules, refer to the specific module documentation.

Filler Plate

Filler plates are available for the two chassis variants that have module slots. If the module
slot is empty, a filler plate (blank panel) must be installed to help control airflow, help confine
electromagnetic interference, and for safety reasons.

T1/E1 and Ethernet Ports

Two variants of the 7705 SAR-M chassis are equipped with T1/E1 ports. All variants of the
7705 SAR-M chassis are equipped with Ethernet ports.
Ethernet interface ports. These ports provide access for a wide variety of interface speeds and
types, including Ethernet (1000Base-T and optical), T1/E1 with ATM and IMA, and TDM
(channelized and unchannelized).
The chassis variants with 16 T1/E1 ports support those connections via RJ-45 connectors. All
16 ports must be configured as either T1 or E1; a mix of T1 and E1 ports is not supported.
The T1/E1 ports are on-premises, intra-building SELV ports and must only be connected to
other SELV ports. Odd-numbered ports are located on the top row, and even-numbered ports
are located on the bottom row.
60
Figure 11: Module Slot
Module slot
1
2
3
Link 4
5
Link
Link
Link Act
Link Link
Act
Act
Act
Act
Figure 12: Filler Plate
7705 SAR-M Chassis Installation Guide
T1/E 1 Ports
1
3
Stat 5
Stat 7
Stat 9
Stat
Stat
6
7
Act Link
Act
2
Figure 12 shows the filler plate.
Figure 13 identifies the T1/E1 and
21102
21283