Checking The Filter System; Putting The Integrated Water Softener Into Operation - Winterhalter UC series Manual

8

Checking the filter system

9

Putting the integrated water softener into operation

INFO: only for machine with integrated water softener
Only add regeneration salt to the salt container.
This salt should be fine-grained (max. 0.4-7 mm grain size). Salt tablets are not suitable.
Do not add any chemicals, e.g. detergent or rinse aid. These will inevitably cause damage to
Caution
the water softener.
Open the machine door and remove the washing rack from the machine.
Unlock and remove the bottom wash field.
Open the screw cap on the salt container and top up the salt container to the brim with fresh water.
Place the funnel in the filling opening on the salt container and gradually add 3 bags of Winterhalter spe-
cial salt (=1.5 kg).
Remove the funnel and clean any salt residue from the filling area.
Screw the salt container tight again, keeping the cover straight.
Reinsert the bottom wash field. Check whether the wash field rotates easily.
After topping up continue with installing the machine.
Any salt residue must be rinsed off as you continue with installing the machine. Otherwise there
is a risk of rusting in the filling area.
Caution
INFO: The input for total hardness is described in the chapters 11 and 14.2.
Checking the filter system
Check whether there is a filter system in the
dishwashing system and whether it is properly
installed. It comprises:
− Strainer (1)
− Filter cylinder (2)
− Filter bottom (3)
7