Connection Diagram For Mains Connection Cable; Connection Diagram For Europe (Except Belgium With 230V/3/Pe) - Winterhalter UC series Manual

Connection diagram for mains connection cable

6 Connection diagram for mains connection cable
Basic information:
The UC series dishwashing machines can be connected to both 3-phase alternating current and 1-phase
alternating current. The machine contains a connection diagram which indicates the terminals to which the
mains connection cable has to be connected. The boiler heating element is already connected. However,
bridges still need to be set so that the power supply's fuse rating is not exceeded.
INFO: Machines of the variant "Cool" are always delivered with connected mains connection cable and plug-
ged-in jumpers. Proceed with section 7 of this manual.
Procedure:
Size of machine: M, L, XL:
Insert the mains connection cable at the rear of the machine and feed it through the cable duct to the con-
nection terminals.
Tighten the screwed cable gland for strain relief in the electric installation compartment.
Size of machine: S:
Take off the right side cladding.
Insert the mains connection cable at the rear of the machine and feed it to the connection terminals.
Tighten the screwed cable gland for strain relief at the backside of the machine.
Determine which type of power supply is available and how it is fused.
Look for the line in the table with the correct power supply (column U) and the right fusing (column
Read the circled code number in the last column. The following drawing matches each code number to a
connection diagram.
Connect the mains connection cable to the terminals PE to N in accordance with the connection diagram.
Set the bridge(s) in accordance with the connection diagram.
INFO: The machines are supplied as per the connection diagram with code number 1.
The parameter P555 (locking) has to be set in accordance with the fusing (see chapter

6.1 Connection diagram for Europe (except Belgium with 230V/3/PE)

4
).
11.1).