Table of Contents
Advertisement
Reset Config Data [No]
[Yes] erases all configuration data in NVRAM (Non Volatile RAM) area and
create a new table of hardware resources. Configuration Options: [No] [Yes]
If you are facing problems after adding or removing any hardware
components to the system it might be wise to select the [Yes] option once.
This allows the BIOS to reconfigure available hardware resources.
Audio Controller [Enabled]
Setting item to [Enable] will allow the onboard High Definition Audio to
operate properly. Setting item to [Disabled] will remove the onboard audio
controller from PCI config space. Configuration Options: [Enabled] [Disabled]
LAN Controller [Enabled]
This point switches physical ON or OFF the Onboard LAN Controller. The
PXE Boot ROM will be loaded, when the option PXE Boot ROM in the next
line is enabled. Configuration Options: [Disabled] [Enabled]
Display Output to COM3 [No]
Some systems may be configured without a full screen display, just using
a small display connected to the COM3 serial port. [Enabled] will redirect
diagnostic information during PowerOnSelfTest to this serial port, giving
control about the system to smaller displays as well.
Configuration Options: [No] [Yes]
COM-Port 5
This option switches physical ON or OFF the COM-Port 5.
Configuration Options: [Disabled] [Enabled]
Parallel Port Address
This option switches the Parallel Port Adresses.
Configuration Options: [Disabled] [387] [278] [3BC]
After choosing an address the port mode and IRQ are available.
After Power Failure [Last State]
Select whether you want your system to be rebooted after power has been
interrupted. [Power off] leaves your system off and [Last State] reboots your
system if it was active before power loss. Is the key [Power On] selected, the
system will startup anytime power is available.
D425-CPU-Desktop
43
Advertisement
Table of Contents
