Cue Outputs Popover - Universal Audio Arrow Manual

Cue Outputs Popover

Note: For an overview of Arrow's HP cue mix bus, see
The Cue Outputs popover window is where the source signal (either the main monitor mix
or the HP cue mix) for Arrow's front panel headphone jack is selected. To access the Cue
Outputs Popover, click the CUE OUTPUTS button in the Monitor Column.
When Arrow is connected with a Universal Audio Apollo audio interface(s), additional
cue sources and destinations are available as a matrix within the Cue Outputs popover,
reflecting the additional available cue mix buses and hardware outputs with an expanded
I/O system.
Cue Source Select
The HP and MIX switches select the signal source bus for the headphone output on
Arrow's front panel. The bus source name is on the switch. The source for the headphone
output is active when its switch is lit.
The headphone output source can be either the HP cue mix bus or the main monitor mix
bus. Both bus sources cannot be routed to the headphone output at the same time (the
HP cue source is mutually exclusive).
Note: To allow selection of HP for the monitor outputs (via the control room
Monitor Source Select
MIX
When set to MIX (the default), the headphone output signal is Console's main monitor
mix, summed with all DAW outputs that are routed to the monitor outs (if applicable).
Console's main monitor mix faders, mutes and solos are reflected in the headphone
output in this mode.
Arrow Manual
Headphone Output
Source
Cue Outputs popover
switches), the HP source must not be set to MIX.
124
HP Cue Overview.
Close
HP Output
Mono
Console Reference