Display Panel - Universal Audio Arrow Manual

Display Panel

Refer to the illustration below for descriptions in this section.
(7) Channel Selection Indicators
The currently selected input channel is indicated by the lit channel name above its input
meter (CH1 or CH2). Press the PREAMP button (4) to switch between channels 1 & 2.
(8) Input Meters
These meters display the incoming signal level for input channels 1 & 2. Reduce the
channel's preamp gain (see
illuminates.
(9) Input Source Indicators
These indicators show which input source (MIC, LINE, or HI-Z) is active for the selected
channel. Use the Input Select button (5-a) to change the input source.
Note: Hi-Z instrument input is available for channel 1 only.
(10) Monitor Selected Indicator
When lit, the LEVEL knob (1) controls volume the monitor outputs (17). Press the
MONITOR button (3) to activate the monitor controls if this indicator is not already lit.
Note: The MONITOR indicator (10) is RED when the monitor outputs are muted.
(11) Stereo Output Meters
These meters display the main stereo signal output levels.* Output meter levels are
independent of monitor and headphone volume levels. If a red "C" (clip) LED at the top
of the Output Meters illuminates, reduce levels feeding the output(s).
*Exception: If HEADPHONE is currently selected (12) and the Headphone Source
within the CUE OUTPUTS window in the Console software application is set to
HP, these output meters indicate the level being sent to the headphone bus via
Console's headphone sends and/or the DAW.
Arrow Manual
7
8
9
Display panel elements
Setting Hardware Input/Output
13
Levels) if its red clip LED
31
10
11
12
Hardware Controls & Connectors