Rear Panel; Monitor Outputs - Universal Audio Volt 476 Hardware Manual

Rear Panel

(16) Line 3-4 Inputs
Connect input sources for line inputs 3-4 here. These are ¼" balanced
inputs designed for line-level sources, such as synths, external sound
modules, or other line-level sources.
Note: There are no gain controls on the line 3-4 inputs. Any level controls
must be configured in your software.

(17) Monitor Outputs

Connect your stereo speaker system to the monitor outputs. Connect the
left speaker to Monitor 1/L and the right speaker to Monitor 2/R. You can
use TS (tip-sleeve) or TRS (tip-ring-sleeve) ¼" (6.35mm) cables.
MONITOR NOTES
The sources that you hear in the monitor and headphone outputs
•
are assigned using the Monitor Source buttons (11). To hear your
computer or software in the monitor speakers and headphones,
Monitor Source OUT 1-2 must be enabled. These outputs are
enabled by default.
When you enable direct inputs with the Monitor Source IN
•
buttons, you will hear those inputs on the monitor outputs and