Audio Setup - Universal Audio Arrow Manual

Audio Setup

Connect to Input Sources and Monitor System
One typical Arrow audio setup is illustrated below. For complete details about all of
Arrow's connectors and controls, see the
manual.
Instrument
Speaker
System
Audio Connection Notes
• Important: When plugging into a rear panel combo jack input, the input source
jack (either XLR or ¼" phone) must be manually selected with the top panel
INPUT button when in
and LINE when connecting ¼" phone plugs. See
• When an instrument is plugged into the front panel Hi-Z jack, channel 1
automatically switches to the Hi-Z input. To use a MIC or LINE input with channel
1, the Hi-Z instrument jack must be disconnected.
• The main outputs are line level. Connect the main outputs to the line level inputs
of powered monitors or an amplifier+speaker system. Balanced TRS or unbalanced
TS cables with ¼" plugs may be used.
• In the illustration above, the microphone is plugged into input 2 so the mic
(channel 2) can be used at the same time as the Hi-Z instrument (channel 1).
• For optimum sonic performance, always use high-quality shielded audio cables.
Arrow Manual
Hardware Controls & Connectors
Typical Arrow audio connections
PREAMP Mode. Select MIC when connecting XLR plugs,
22
chapter in this
Headphones
Microphone
Controls Overview for details.
Getting Started