Monitor Outputs - Universal Audio Volt 1 Hardware Manual

The rear panel is used to make audio output connections, the USB
connection to the computer, and MIDI connections.

(11) Monitor Outputs

Connect your stereo speaker system to the monitor outputs.
Connect the left speaker to Monitor 1/L and the right speaker to
Monitor 2/R. You can use TS (tip-sleeve) or TRS (tip-ring-sleeve)
¼" (6.35mm) cables.
BALANCED AND UNBALANCED CONNECTIONS
The outputs on Volt are balanced when connected with
•
TRS connectors to balanced equipment.
Use TRS (balanced) audio cables for the best results with
•
a balanced stereo speaker system. Balanced equipment
uses three conductor wiring to reduce interference and
electrical noise, and to provide better audio quality over
longer cable runs. TS connections may be suitable for
shorter output cables, where electrical interference noise
may not be an issue.
Note: The monitor outputs are not powered. You will need to
connect the cables to either powered speakers or an amp with
speakers.
(12) MIDI I/O
You can connect a MIDI device to Volt with standard 5-pin MIDI
DIN cables. Connect the MIDI OUT of your device to the MIDI IN
on Volt, and the MIDI IN of the device to the MIDI OUT on Volt.
You may not need to make both connections. For example, a MIDI
controller might only be connected to the MIDI IN on Volt, and a
MIDI sound module might only be connected to the MIDI OUT
from Volt.
(13) USB-C
Connect Volt to a USB 2.0 (or higher) port on your computer with
a USB-C to USB-A cable (included), or with another cable.