Cutting, Sawing And Scraping; Operation - Makita TM3000C Instruction Manual

1
Application tool installation bolt 2. Hex wrench
3. Tighten
Put an application tool (optional accessory) on the tool
holes in the application tool and secure the application
When using sanding application tool, mount the appli-
cation tool on the sanding pad so that it matches the
sanding pad direction.
As sanding papers have holes for dust extraction,
mount a sanding paper so that the holes in a sanding
paper match those in the sanding pad.
To remove a sanding paper, raise its end and peel it off.
Loosen and remove the application tool installation bolt
using a hex wrench and then take off the application tool.
1
2
3
4
Application tool installation bolt 2. Holes in the
application tool 3. Adapter 4. Protrusions of the tool
When using application tools with a different type of instal-
lation section, use a correct adapter (optional accessory).

OPERATION

WARNING:
Before starting the tool and during operation, keep
your hand and face away from the application tool.
CAUTION:
may cause a motor lock and stop the tool.
2
3

Cutting, sawing and scraping

CAUTION:
(eg. towards either side) of tool application with
no cutting edge. It may damage the tool.
Put the application tool on the workpiece.
And then move the tool forward so that the application
tool movement does not slow down.
NOTE:
preset the orbital stroke rate 3 - 5.
Sanding
CAUTION:
metal to sand wood.
paper without grit.
Apply a sanding paper on the workpiece.
NOTE:
mendable to determine a correct orbital stroke
rate suitable for your work.
sanding the whole workpiece is completed.
Replacing a sanding paper with different grit
6 ENGLISH
-