Table of Contents
Advertisement
LOADING YOUR DISHWASHER
Alternative modular basket position
Alternative basket loads
Lower Basket
20
LOADING YOUR DISHWASHER
MAINTENANCE AND CLEANING
TIPS & INFORMATION
IMPORTANT
Cleaning the machine in regular intervals prolongs the
machine's service life.
Oil and lime may accumulate in the machine's
washing section. In case of such accumulation;
•
Fill the detergent compartment without loading any
dishes into the machine, select a program that runs
at high temperature, and start the machine. In case of
insufficiency, use special cleansing material available
in the market. (Cleansing material produced special
to machines by detergent producers.)
Cleaning the seals in the machine door
•
To clean any accumulated residues in the door seals,
wipe the seals regularly by using a dampened cloth.
Cleaning the machine
•
Clean the filters and spray arms at least once a week.
•
Unplug your machine and turn off its tap before
starting the cleaning.
•
Do not use hard materials when cleaning your
machine. Wipe with a fine cleaning material and a
dampened cloth.
Filters
•
Check if any food wastes have remained on the
coarse and fine filters.
•
If any food wastes are left, remove the filters and
clean them thoroughly under the water tap.
a
Micro Filter
b
Coarse Filter
c
Metal/Plastic Filter
To remove and clean the filter combination, turn it counter
1
clockwise and take it out by lifting upwards.
Pull and remove the metal/plastic filter.
3
Then pull the coarse filter out of the micro filter.
2
Rinse it with lots of water under the tap. Refit the
metal/plastic filter. Insert the coarse filter into the micro
filter in away that the marks will correspond to one
another. Attach micro filter into the metal/plastic filter
and turn to the direction of arrow and it is locked when
4
the arrow on micro filter can be seen from across.
•
Never use your dishwasher without any filter.
•
Incorrect fitting of the filter will reduce the washing
effectiveness.
•
Clean filters are very important in terms of the proper
running of the machine.
.
c
1
3
b
a
2
4
Spray arms
Check whether or not the holes for the upper and lower
spray arms are clogged. If there is any clogging, remove
the spray arms and clean them under water.
You can remove the lower spray arm by pulling it
upwards, while the upper spray arm nut can be removed
by turning the nut to the left.
Be sure that the nut is perfectly tightened when refitting
the upper spray arm.
Hose filter
Water is stopped by the inlet hose filter to avoid any
damage to your machine because of any contamination
(sand, clay, rust etc.) that might be occasionally carried in
through the mains water supply or the indoor plumbing,
and to forestall such issues as yellowing and formation of
deposits after washing. Check the filter and the hose from
time to time and clean them if necessary.
To clean the filter, first turn off your tap and then remove
the hose. After removing the filter from the hose, clean it
under the tap. Insert the cleaned filter back into its place
inside the hose. Refit the hose.
MAINTENANCE AND CLEANING
21
Hide quick links:
Advertisement
Table of Contents
