Hints And Tips - Westinghouse WSF67251 User Manual

HINTS AND TIPS

If one of program monitor lights is on and
start/pause light is flashing
• Your machine's door is open, shut the door
to continue.
If the program won't start
• Check if the plug is connected.
• Check your indoor fuses.
• Check that the water inlet tap is turned on.
• Check that you have closed the machine door.
• Check that you switched off the machine by
pressing the power on/off button.
• Check that the water inlet filter and the machine
filters are not clogged.
If the control light is off after a wash operation
• The power on/off button isn't released yet.
If detergent residues are left in the detergent
compartment
• Detergent has been added when the detergent
compartment was wet.
• Large dishes have blocked the dispenser door.
If water is left inside the machine at the end of the
program
• The water drain hose is clogged or twisted.
• The filters are clogged.
• The program is not finished yet.
IMPORTANT
TIPS & INFORMATION
At the end of the program, water may still remain on the
sides and door of the appliance.
If the machine stops during a wash operation
• Power failure.
• Water inlet failure.
• Program is on standby mode.
If shaking and hitting noises are heard during
a wash operation
• Dishes are placed incorrectly.
• The spray arm is hitting the dishes.
10
HINTS AND TIPS
If there are partial food wastes left on the dishes
• Dishes are placed incorrectly into the machine,
sprayed water did not reach related places.
• Basket overloaded.
• Dishes leaning against one another.
• Very small amount of detergent added.
• An unsuitable, rather weak wash program selected.
• Spray arm clogged with food waste.
• Filters clogged.
• Filters incorrectly fitted.
• Water drain pump clogged.
If there are white stains on the dishes
• A very small amount of detergent is being used.
• Rinse aid dosage setting at a very low level.
• Water hardness is very high.
If the dishes won't dry
• A program without a dry operation selected.
• Rinse aid dosage set too low.
• Dishes unloaded too fast.
• Use a hotter program
If there is rust on the dishes
• Stainless-steel quality of the dishes washed
is insufficient.
• High level of salt in the wash water.
• Unhealthy mains grounding.
Unloading the baskets
• For improved drying results with the most effective
use of energy, open the door approximately 10cm at
the end of the program.
• Allow the tableware to cool for 30-40 minutes as hot
items can easily be damaged.
• First remove items from the lower basket before
removing the items from the upper basket.
Call an authorised service if the problem still
persists after the controls or in case of any
malfunction not described above.
Useful Information
• Whenever you will not be operating your machine:
- Unplug the machine and then turn water off.
- Leave the door slightly ajar in order to prevent the
formation of unpleasant smells.
• Keep the machine interior clean.
• Correct loading of dishes in the machine, enables
reduced energy consumption and improved washing
and drying performance.
• Remove all large food remnants before you placing
dirty dishes into the machine.
• Operate the machine after it is completely full.
• If the appliance is located in a place where the risk of
freezing exists, you must completely drain the water
that has remained in the machine. Turn off the water
tap, disconnected the water inlet hose from the tap
and allow the interior water to drain.
INSTALLATION
General
• When determining where to put your machine,
choose a place where you can easily load and unload
your dishes.
• Do not put your machine in any location where
there is a probability for the room temperature to
fall below 0°C.
• Before positioning, take the machine out of its
packaging by following the warnings located on
the package.
• Position the machine close to a water tap or
drain. You need to site your machine, taking into
consideration that its connections will not be altered
once they are made.
• Do not grip the machine by the door in order to move it.
• Leave a clearance on all sides of the machine so that
you can comfortably move it back and forth during
cleaning.
• Make sure that the water inlet and outlet hoses
aren't squeezed while positioning the machine.
Also, make sure that the machine does not stand
on the electrical cable.
• Adjust the machine's adjustable feet so that it can
stand level and balanced. Proper positioning of the
machine ensures problem-free opening and closing of
the door.
• If the door of your machine does not close properly,
check if the machine is stable on the floor it stands;
if not, adjust the feet and ensure its stable position.
Water connection
Connect the inlet hose to a water tap with an external
BSP thread spout of 3/4". The indoor plumbing is to
comply with AS/NZS 3500.1.
For best washing performance it is recommended to
connect the appliance to a cold water supply.
Energy savings can be made by connecting the appliance
to a solar water system and using economy options,
however the water temperature must not exceed 60°C
CAUTION WARNING
Only turn the locking nut to secure the hose. Do not
turn the hose.
Inlet water supply
• Water pressure: 800kPa max – 50 kPa min.
• Water flow rate 10 L/minute
• If water pressure is in excess of 800 k Pa, a pressure
reducing valve should be used. Check for leaks.
• If water temperature is in excess of 60°C, a tempering
valve should be used. Check for leaks.
WARNING CAUTION
Always use new hoses when you connect the appliance to
the water mains. Old hoses must not be used. The water
inlet hose must be examined at an interval of twelve
months for deterioration and replaced if necessary.
In order to pass the safety valve through the kitchen
cabinets, an opening of at least 45mm x 90mm is needed.
30cm
min.
Water drain hose
min. 4cm
Floor level
The water drain hose can be connected either directly to
the water drain hole or to the sink outlet spigot. Using a
special bent pipe (if available), the water can be drained
directly into the sink via hooking the bent pipe over the
edge of the sink. This connection should be at a minimum
of 50cm and at a maximum of 110cm from the floor.
WARNING
CAUTION
When a drain hose longer than 4m is used, the dishes
wont be cleaned properly and might remain dirty.
INSTALLATION
11