Maintenance And Cleaning 20 - Westinghouse WSF6604WA User Manual

MAINTENANCE AND CLEANING
TIPS & INFORMATION
IMPORTANT
Cleaning the machine in regular intervals prolongs the
machine's service life
Oil and lime may accumulate in the machine's
washing section. In case of such accumulation;
• Fill the detergent compartment without loading
any dishes into the machine, select a program that
runs at high temperature, and start the machine If
this is ineffective, use a specialty dishwasher cleaner
available from most supermarkets
Cleaning the seals in the machine door
• To clean any accumulated residues in the door seals,
wipe the seals regularly by using a dampened cloth
Cleaning the machine
• Clean the filters and spray arms at least once a week
• Unplug your machine and turn off its tap before
starting the cleaning
• Do not use hard materials when cleaning your
machine Wipe with a fine cleaning material and a
dampened cloth
Filters
• Check if any food wastes have remained on the
coarse and fine filters
• If any food wastes are left, remove the filters and
clean them thoroughly under the water tap
a Micro Filter
b Coarse Filter
c Metal/Plastic Filter
To remove and clean the filter combination, turn it counter
clockwise and take it out by lifting upwards
Pull and remove the metal/plastic filter
Then pull the coarse filter out of the micro filter
Rinse it with lots of water under the tap Refit the
metal/plastic filter Insert the coarse filter into the micro
filter in away that the marks will correspond to one
another Attach micro filter into the metal/plastic filter
and turn to the direction of arrow and it is locked when
the arrow on micro filter can be seen from across
• Never use your dishwasher without any filter
• Incorrect fitting of the filter will reduce the washing
effectiveness
• Clean filters are very important in terms of the proper
running of the machine
20
MAINTENANCE AND CLEANING
.
Spray arms
Check whether or not the holes for the upper and lower
spray arms are clogged If there is any clogging, remove
the spray arms and clean them under water
You can remove the lower spray arm by pulling it
upwards, while the upper spray arm nut can be removed
by turning the nut to the left
Be sure that the nut is perfectly tightened when refitting
the upper spray arm
1
3
2
Hose filter
Water is stopped by the inlet hose filter to avoid any
damage to your machine because of any contamination
4
(sand, clay, rust etc) that might be occasionally carried in
through the mains water supply or the indoor plumbing,
and to forestall such issues as yellowing and formation
of deposits after washing Check the filter and the hose
from time to time and clean them if necessary To clean
the filter, first turn off your tap and then remove the hose
After removing the filter from the hose, clean it under the
tap Insert the cleaned filter back into its place inside the
hose Refit the hose
1
c
b
a
2
3
4