Suzuki FD 110 XCS Service Manual page 8

* If parts replacement is necessary, replace the parts with Suzuki Genuine Parts or their
equivalent.
* When removing arts that are to be reused, keep them arranged in an orderly manner so that
they may be reinstalled in the proper order and orientation.
* Be sure to use special tools when instructed.
* Make sure that all parts used in reassembly are clean, and also lubricated when specified.
* When use of a certain type of lubricant, bond, or sealant is specified be sure to sue the
specified type.
* When removing the battery, disconnect the negative cable first and then positive cable. When
reconnecting the battery, connect the positive cablefirst and then negative cable, and replace
the terminal cover on the positive terminal.
* When performing service to electrical arts, if the service procedures not require use of battery
power, disconnect the negative cable of the battery.
* Tighten cylinder head case bolts and nuts, beginning with larger diameter and ending with
smaller diameter, from inside to outside diagonally, to the specified tightening torque.
* Whenever you remove oil seals, gaskets, packing, O-rings, locking washers, cotter pins, cir-
clips and certain other parts as specified, be sure to replace them with new ones. Also, before
installing these new parts, be sure to remove any left over material from the mating surfaces.
* Never reuse a circlip. When installing a new circlip, take care not to expand the end gap larger
than required to slip the circlip over the shaft. After installing a circlip, always ensure that it is
completely seated in its groove and securely fitted.
* Do not use self-locking nuts a few times over.
* Use a torque wrench to tighten fasteners to the torque values when specified. Wipe off grease
or oil if a thread is smeared with them.
* After reassembly, check parts for tightness and operation.
* To protect environment, do not unlawfully dispose of used motor oil and other fluids:
batteries, and tires.
* To protect Earth's natural resources, properly dispose of used vehicles and parts.
GENERAL INFORMATION 1-3