Suzuki FD 110 XCS Service Manual page 20

• Remove spark plug, valve inspection caps 1 and valve timing
inspection plug 2.
• Remove the magneto cover cap and rotate the magneto rotor
with box wrench to set the piston at (TDC) of the compression
stroke. (Rotate the rotor until the "T" line on the rotor is
aligned with the center of hole on the magneto cover.
• Insert the thickness gauge to the clearance between the valve
stem end and the adjusting screw on the rocker arm.
09900-20803: Thickness gauge
• If clearance is off the specification, bring it into the specified
range by using the special tool.
• Reinstall spark plug, valve inspection caps, valve timing
inspection plug and magneto cover cap.
09917-14910: Tappet adjust driver
NOTE:
* The clearance specification is for GOLD state
PERIODIC MAINTENANCE
1
2
Adjuster Screw
Rockerarm
Valve clearance
2-7