Engine Reassembly - Suzuki FD 110 XCS Service Manual

ENGINE REASSEMBLY

The engine is reassembled by carrying out the steps of disassembly in the reversed order, but there are a
number of steps which demand special description or precautionary measures.
NOTE:
Apply engine oil to each running and sliding part before reassembling.
CRANKSHAFT
• Decide the width between the webs referring to the figure
below when rebuilding the crankshaft.
Standard width between webs: 42.0 ± 0.1 mm
• When installing the crankshaft into the crankcase, it is
necessary to pull its left end into the left crankcase by using
the special tools.
• Apply engine oil to the crankshaft bearings.
09910-32812: Crankshaft installer
09910-32820: Spacer
09911-11310: Attachment
Never install the crankshaft into the crankcase by
striking it with a plastic hammer. Always use the
special tool, otherwise crankshaft alignment accuracy
will be affected
ENGINE 3-31
MM.