Using Auto-Tftp For Ipv6 - HP 2520-8 Configuration Manual

< ipv6-addr >: If this is a link-local address, use this IPv6
address format:
fe80::< device-id >%vlan< vid >
For example:
If this is a global unicast address, use this IPv6 format:
< ipv6-addr >
For example:
oobm: For switches that have a separate out-of-band manage-
ment port, specifies that the transfer will be through the out-
of-band management interface. (Default is transfer through
the data interface.)

Using Auto-TFTP for IPv6

At switch startup, the auto-TFTP for IPv6 feature automatically downloads a
software image to the switch from a specified TFTP server, then reboots the
switch. To implement the process the switch must first reboot using one of
the following methods:
enter the boot system flash primary command in the CLI
■
■ with the default flash boot image set to primary flash (the default), enter
the boot or the reload command, or cycle the power to the switch. (To
reset the boot image to primary flash, use boot set-default flash primary.)
fe80::123%vlan10
2001:db8::123
IPv6 Management Features
TFTP File Transfers Over IPv6
2-19