HP 2520-8 Configuration Manual page 79

HP Switch# ipv6 authorized-managers 2001:db8::a8:1c:e3:69
HP Switch# show ipv6 authorized-managers
IPv6 Authorized Managers
--------------------------
Address : 2001:db8::a8:1c:e3:69
Mask : ffff:ffff:ffff:ffff:ffff:ffff:ffff:ffff
Access : Manager
If you do not enter a value for ipv6-mask in the ipv6 authorized-managers command, the default mask of
FFFF:FFFF:FFFF:FFFF:FFFF:FFFF:FFFF:FFFF: is applied. The default mask authorizes only the specified station (see
"Configuring Single Station Access" on page 3-3).
Figure 3-11. Default IPv6 Mask
Switch(config)# ipv6 authorized-managers
fe80::07be:44ff:fec5:c965%vlan2
Switch(config)# ipv6 authorized-managers
fe80::070a:294ff:fea4:733d%vlan2
Switch(config)# ipv6 authorized-managers
fe80::19af:2cff:fe34:b04a%vlan5
If you do not enter an ipv6-mask value when you configure an authorized IPv6
address, the switch automatically uses FFFF:FFFF:FFFF:FFFF:FFFF:FFFF:FFFF:FFFF
as the default IPv6 mask. Also, if you do not specify an access value to grant
either Manager- or Operator-level access, by default, the switch assigns Man-
ager access. For example:
The next IPv6 command authorizes operator-level access for sixty-four IPv6
stations: thirty-two stations in the subnets defined by 0x0006 and 0x0007 in
the fourth block of an authorized IPv6 address:
Switch(config)# ipv6 authorized-managers
2001:db8:0000:0007:231:17ff:fec5:c967
ffff:ffff:ffff:fffe:ffff:ffff:ffff:ffe0 access operator
The following ipv6 authorized-managers command authorizes a single, automat-
ically generated (EUI-64) IPv6 address with manager-level access privilege:
Switch(config)# ipv6 authorized-managers
::223:04ff:fe03:4501 ::ffff:ffff:ffff:ffff
IPv6 Management Security Features
Authorized IP Managers for IPv6
3-11