HP 2520-8 Configuration Manual page 62

IPv6 Management Features
TFTP File Transfers Over IPv6
2-20
Syntax: auto-tftp <ipv6-addr > <filename >
Configures the switch to automatically download the
specified software file from the TFTP server at the specified
IPv6 address. The file is downloaded into primary flash
memory at switch startup. The switch then automatically
reboots from primary flash.
Notes: To enable auto-TFTP to copy a software image to
primary flash memory, the version number of the down-
loaded software file (for example,S_14_01.swi) must be
different from the version number currently in the
primary flash image.
The current TFTP client status (enabled or disabled)
does not affect auto-TFTP operation. (Refer to "Enabling
TFTP for IPv6" on page 2-15.)
Completion of the auto-TFTP process may require
several minutes while the switch executes the TFTP
transfer to primary flash, and then reboots again.
The no form of the command disables auto-TFTP operation
by deleting the auto-tftp entry from the startup configuration.
The no auto-tftp command does not affect the current TFTP-
enabled configuration on the switch. However, entering the
ip ssh filetransfer command automatically disables both auto-
tftp and tftp operation.