External Output Signal; Power Conservation Features; Battery Operation - Kustom Signals Pro-Lite Reference Manual

EXTERNAL OUTPUT SIGNAL

The I/O connector on the front side of the Pro-Lite
provides a means to connect an external computer, data
storage or Giant Display device to the instrument. In a
typical application, this might be used to display or store
speed-readings from the Pro-Lite. The connector used for
this signal is a 3-pin subminiature stereo jack. If you have
trouble obtaining a compatible plug locally, the mating part
can be ordered through Kustom Signals' Customer Service
Department.

POWER CONSERVATION FEATURES

After approximately 20 seconds with no activity and no
locked speed or range readings, the Pro-Lite enters "sleep"
mode. To restore the unit to normal operation, press the
FIRE/ENTER switch. If there is a locked speed and/or
range reading, it will blank from the HUD, but remain on
the rear panel LCD. Depressing the trigger will erase these
readings.
The unit also turns off if no activity has occurred after
a period of time in the locked speed Mode. An audio chirp
sounds to alert the operator that the unit is powering
down.
NOTE:

BATTERY OPERATION

When the battery power becomes too low for operation
(the Low Voltage Alert or Low Voltage Warning appears on
the display), unscrew the battery compartment door and
remove the 2 "AA" batteries. The "+" battery is on top.
Pro-Lite Operator's Manual
A locked speed or range remains on the
display during "Sleep" mode. Pressing the
trigger clears the display.
Page 34