Table of Contents
Advertisement
4.2 Hang-Mount Bracket Installation Steps
4.2.1 Installation Conditions
Hang-mounted speed dome can be installed on hard wall structure in both indoor and outdoor
environments. The wall needs to meet the following installation conditions:
The wall shall be thick enough to install expansion bolts.
The wall needs to sustain at least 8X weight of the camera.
4.2.2 Installation Steps
Step 1
Take the mounting holes of connection plate for hang-mounted bracket, draw the location of
mounting holes on the ceiling and dig holes, then pre-bury the expansion bolts into the holes you
just dug, which is shown in Figure 4-4.
Note
If the speed dome is used in the indoor environment, it needs to cover silica gel on the contact
surface between connection plate and ceiling, and the surrounding area of the cable exit hole,
which is to make it sealed and waterproof.
Step 2
Figure 4-3
Figure 4-4
16
Hide quick links:
Advertisement
Table of Contents
