Dahua SD6C230U-HNI Installation Manual page 24

Install hang-mounted component

Without Straight Pole
Fix the connection plate of hang-mounted bracket on the ceiling, and then twist the adapter block
into the connection plate, which is shown in Figure 4-5.

With Straight Pole
First it needs to fix the connection plate of hang-mounted bracket on the ceiling, and then twist
the straight pole into the connection plate, finally twist the adapter block into the straight pole of
the hang-mounted bracket, which is shown in Figure 4-6.
Step 3
Connect the power cable, video cable, audio cable, RS-485 control cable, alarm cable, network
cable, high-frequency cable and optical fiber cable etc. well according to requirements, and then
use insulated rubber tape to twine the cable connection well respectively to make it waterproof.
Note
Figure 4-5
Figure 4-6
17