Philips DVDR980/001 Service Manual page 34

EN 34 4. DVDR980-985 /0X1
4.1.4 Analog board
To put the analog board in service position, demount the
assembly of analog board and backplate as follows:
1. Remove 3 screws from the backplate to the frame
2. Remove the screw from the backplate to the mains inlet of
the power supply
3. Remove the screw of the analog board to the frame
4. Release the snaps of the 4 spacers of the analog board to
the frame.
Turn the assembly of the backplate and the analog board
against the loader.
Analog Europe
Figure 4-7
Analog NAFTA
Figure 4-8
Mechanical Instructions