Input Format - Philips DVDR980/001 Service Manual

Circuit-, IC Descriptions and List of Abbreviations
Multi-channel filter DAC
8.7.2 D -
E EMPHASIS CONTROL
In static pin mode the pins DEEM0 and DEEM1 control the
de-emphasis mode; see Table 3.
Table 3 De-emphasis control
DEEM MODE
No de-emphasis
32 kHz de-emphasis
44.1 kHz de-emphasis
48 kHz de-emphasis
8.7.3 D
IGITAL INTERFACE FORMATS
In static pin mode the digital audio interface formats can be
selected via pin 17 (SF1) and 19 (SF0). The following
interface formats can be selected (see also Table 4):
• I
2
S-bus with data word length of up to 24 bits
• LSB-justified format with data word length of
16, 20 or 24 bits.
Table 4 Input format selection in the static mode

INPUT FORMAT

2
I S-bus
LSB-justiÞed 16 bits
LSB-justiÞed 20 bits
LSB-justiÞed 24 bits
It should be noted that the digital audio interface holds that
the BCK frequency can be 64 times the WS maximum
≤ 64 × f
frequency, or f
BCK
DEEM1 DEEM0
0 0
0 1
1 0
1 1
SF1 SF0
0 0
0 1
1 0
1 1
WS
DVDR980-985 /0X1
8.8 L3 mode
The device is set to L3 mode by setting the STATIC pin to
LOW. The device can then be controlled via the L3
microcontroller interface (see Chapter 9).
8.8.1 D
IGITAL INTERFACE FORMATS
The following interface formats can be selected in the
L3 mode:
• I
2
S-bus with data word length of up to 24 bits
• MSB-justified with data word length of up to 24 bits
• LSB-justified format with data word length of 16, 18,
20 or 24 bits.
8.8.2 L3
ADDRESS
The UDA1328 can be addressed via the L3 microcontroller
interface using one of two addresses. This is done in order
to individually control the UDA1328 and other Philips
DACs or CODECs via the same L3 bus.
The address can be selected using pin 25 (DEEM0) in
L3 mode. When pin 25 is set LOW, the address is 000100.
When pin 25 is set HIGH the address is 000101.
9. EN 181
UDA1328T