Makita PT354D Instruction Manual page 7

A
1.
1
1. 2. Flush 3.
Lighting up the lamp
CAUTION:
Do not look in the light or see the
source of light directly.
Pull the switch trigger or actuate the contact element to
ing the switch trigger or actuating the contact element.
releasing the switch trigger and the contact element.
1
1. Lamp
NOTE: Use a dry cloth to wipe the dirt off the lens of
the lamp. Be careful not to scratch the lens of lamp, or
it may lower the illumination.
NOTE: Even in the lamp lights up when the battery
nails. In this case, charge the battery cartridge.
1
B
2 3
ASSEMBLY
CAUTION:
are not placed on the switch trigger or the contact
element and the battery cartridge is removed
before carrying out any work on the pin nailer.
Loading the pin nailer
CAUTION:
Always make sure that the battery
cartridge is removed before loading the pin nailer.
property damage.
CAUTION:
Do not abruptly slide the magazine
of the pin nailer loaded with pin nails.
dropping pin nails especially when working in high
CAUTION:
Load pin nails in the correct direction.
Loading in wrong direction may cause premature wear
and tear of the driver and damage of the other parts.
CAUTION:
Do not use deformed connected
pin nails.
1. Remove the battery cartridge.
2. Press the locking lever and slide the magazine
backward.
3.
bottom of the magazine and push the whole part of pin
nails toward the driver guide. (Be careful to place pin
nails in the right direction.)
-
1
4
1. Pin nails 2. Magazine 3. Locking lever 4. Driver
guide
7 ENGLISH
3
2