Cable Management; Maintenance And Cleaning; Troubleshooting - Steelcase Ology User Manual

Cable Management

When installing equipment, either on the worksurface or below,
be sure that the connecting cables are free from obstruction.
Ology offers a cable riser, cable brackets or a cable basket to help
manage excess cables/wires on the underside of the worksurface.
Workstation Design Tips
•
Ensure that power cords for all accessory items – computer,
lights, monitors, etc. – are of sufficient length to reach outlets
throughout the range of worksurface height adjustment.
Do not subject the cords to any strain while height adjustment
is taking place.
•
Always check for proper operating clearance before placing
any item on, above or below the worksurface.
•
Please use a volt meter to ensure that every outlet into which
a height adjustable desk will be connected has 120 volts,
plus or minus 10 volts, between the hot and neutral contacts
(the parallel openings) BEFORE the height-adjustable desk is
plugged in. If this voltage reading is above 130 volts, please
contact the building electrician for correcting the building wiring.

Maintenance and Cleaning

Regularly clean dust and dirt from lifting columns. To ensure all
surfaces are thoroughly cleaned, make sure the lifting columns are
fully extended to their maximum height. Also, be sure to inspect
cables and lifting columns for damage. Check all connections for
both correct function and secure mounting.
A damp cloth is recommended. To protect the painted
Caution:
surfaces, use a cleanser that is not highly alkaline or acidic.
A pH-neutral product is ideal.
Note: Please do not move the desk without help. Refer to the
guidelines at the end of the assembly instructions, or contact your
facilities group for assistance.

Troubleshooting

If you are having trouble with your desk, try the simple steps
outlined below. If problems persist, please refer to the Ology
troubleshooting guide.
POWER-SAVING CONTROL BOX:
•
The control box automatically powers down into 'standby' mode
after 10 seconds of inactivity.
•
During standby mode, the control box only consumes
0.1 watt of power.