Steelcase Ology User Manual page 6

4 Preset Programmable Controller
with Digital Display
OPERATING THE CONTROLLER
•
Press and hold either the
desired height. The digital-display controller will display the
current height of the desk.
•
To switch to a stored height in memory, use the four memory
position buttons. Press and hold the numbered button that has
the saved height stored into memory.
•
The user must continuously hold down the button in order for
the desk to move.
STORE HEIGHT INTO MEMORY
To set into memory the desired height for either seated or standing
work, use the four memory position buttons.
•
Press either the
•
Press the
•
The digital-display will flash
time press your choice of memory position buttons 1-3 or the
collaboration button to set that particular height. The digital-
display will store by showing s1,
•
To save additional heights repeat this sequence using the
remaining three buttons.
•
Recommended collaboration height should be set to 40".
ADJUSTING THE HEIGHT DISPLAYED
It may be necessary to adjust the height displayed. The controller
will show 68 cm or 22.6" at its lowest setting, which is the default
setting from the factory.
•
At the same time press the
button, until the digital-display shows the correct height.
SWITCH DISPLAY FROM INCHES TO CENTIMETERS
Press and hold the
inches to centimeters.
ERROR CODES
In the event of a fault, the digital-display may show an error code.
Refer to the Ology troubleshooting guide for further instructions.
up or down
button once.
s
s button to change the displayed height from
up or down button to reach the
button to reach the desired height.
s for three seconds. During this
s2, s3
s button and the
or s4 for one second.
up or down