Advance Management Functions - Compex SGX3224 Quick Install Manual

♦ ♦ FD LEDs
Full Duplex LED (Green):
Lights up when port is running at Full Duplex.
(F D )
ULL UPLEX
When FD LEDs do not light up for Full Duplex mode,
check that:
1.The device is configured as Full Duplex mode.
Advance Management Functions Setup Procedures:
In this section, the procedure of setting up the following functions would be
discussed:
1. Transmission mode of each port;
2. Port VLAN set up;
3. Viewing of basic statistics;
4. Saving of current configuration;
5. Restoring default configuration;
Since all the above functions are being set up through management interface
(either Web Browser Interface or Command Line Interface), we need a PC with
TCP/IP protocol so that it can run a Web browser program like IE4 or Netscape
4. Furthermore, in order to communicate with SGX3224, you need to set up the
IP address of SGX3224 through the following means:
1. Default IP address
Just use the default IP address; default IP address is 192.168.168.99 with
subnet mask 255.255.255.0 and default gateway 192.168.168.1.
2. BootP Server
BootP server that can assign IP address, SGX3224 will automatically look
for a BootP server during power up and get a valid IP address. Consult your
BootP server document on how to set up IP address for SGX3224.
3. Command Line Interface
Using Command Line Interface to set up the IP address; in Command Line
Interface, there is a command "set ip address xxx.xxx.xxx.xxx
yyy.yyy.yyy.yyy" where x is the new IP address and y being the subnet
mask. The detail procedures are:
a) You need a PC with one free COM port (COM1 or COM2); this PC
must be running Windows95 or Windows98. Run the HyperTerminal
English Compex 24 - Port All 10/100 Management Switch
(SGX3224, SGX3224 PLUS)
9