Page 1
Series: Convection Please read the instructions carefully before use. Take good care of this manual for later use.
Page 2
Prospering on our success in the Nordics we decided to promote Mill at some of the world’s largest electronic fairs and home shows in 2015 and 2016 - the feedback from retailers and distributors all over the world were amazing.
millheat.com Content P. 2-3 Important safety information P. 4 Specifications P. 4 Before first use P. 4 First use P. 4 Description of heater P. 5 Parts P. 5 Assembly P. 5 Instructions mechanical thermostat P. 6 Usage mechanical thermostat P.
Important safety information You must obey common safety guidelines when using electrical products, especially in the presence of children. WARNING! To avoid electric shock or damage due to the heat, always make sure the plug is pulled out before the heater is moved or cleaned.
Page 5
millheat.com • Never touch an electric heater with wet hands. The heater should be installed so a person showering or taking a bath cannot come into direct contact with it. • The heater becomes hot when it is on. Therefore, be careful and avoid burning or scorching your skin.
Model Thermostat Color Amperage Power (W) SG2000MEC Mechanical White 220-240V~50/60Hz 1800-2000 SG2000LED Electronic White 220-240V~50/60Hz 1800-2000 SG2000GLASS Electronic White 220-240V~50/60Hz 1800-2000 SG2000LED BLACK Electronic Black 220-240V~50/60Hz 1800-2000 transport. Contact the retailer or importer if you discover any visible damages to the product.
millheat.com Parts Please see table on page 4 for which models that have mechanical/electronic thermostats See figure 2 on separate illustration sheet Mechanical thermostat Electronic thermostat • 4 screws (pre-mounted) • 8 screws (pre-mounted) • 2 foot brackets • 2 foot brackets •...
Usage mechanical thermostat 1. Set the output selector to the OFF position (0) and the thermostat to minimum. Plug the heater into a grounded outlet. 2. Set the output selector to position |, || or |||. Turn the thermostat up to the maximum position.
To adjust this, all Mill heaters are equipped with a calibration function which enables you to adjust the temperature registered by the heater. Please note: the room must have a stable temperature for calibration to work.
Need help?
Do you have a question about the SG2000MEC and is the answer not in the manual?
Questions and answers