Cleaning The Ch1000 Vehicle Cradle - Psion Teklogix IKON RUGGED 7505-BTSDCMHC25 User Manual

• Ensure the mounting has the capacity to hold the cradle and the Ikôn. Cradle plus Ikôn
weight is approximately 1kg (2.2 lb.).
• Psion Teklogix has recommended and approved mounts—consult Customer Service
for information.
Figure 6.11 Removing The RAM Mount Interface
To accommodate the service loop of the power cable, leave a 10.2 cm (4 in.) clearance at the
bottom of the vehicle cradle. Leave a 17.8 cm (7 in.) clearance at the top of the vehicle
cradle to allow easy removal of the Ikôn. When selecting a mounting location, refer to the
detailed assembly instructions that are packaged with the pedestal.
Important: Before Psion Teklogix releases a product, our engineering team exposes
If you elect to use a third party company-produced cradle, Psion Teklogix cannot take re-
sponsibility for the effects of that third party product when it causes failure to our device.
6.9.4

Cleaning The CH1000 Vehicle Cradle

Important: Dampen a soft cloth with mild detergent to wipe the unit clean.
that product to vibration tests to ensure the Ikôn will remain secure during
normal use. But as a low cost mount, the cradle will not defend against
shock if the vehicle undergoes a front or rear impact. Take care to mount
the cradle in an upright position in case of accidents.
Chapter 6: Peripheral Devices & Accessories
Ikôn Rugged PDA (Windows CE 5.0) User Manual

Cleaning The CH1000 Vehicle Cradle

235