Switching The Ikôn Off - Psion Teklogix IKON RUGGED 7505-BTSDCMHC25 User Manual

Rugged pda
Hide thumbs Also See for IKON RUGGED 7505-BTSDCMHC25:
Table of Contents

Advertisement

Chapter 2: Basic Checkout
Switching The Ikôn Off
Note: If the unit was already in use—the unit may be off (suspend state)—pressing
[ENTER] 'wakes' the unit from this state. The screen in which you were working
prior to the suspend state is displayed. "GPS" on page 104 describes how you can
assign other 'wakeup' keys or enable a two-key 'power on' sequence.
Important: If your Ikôn fails to power up, consider the following troubleshooting
2.3.3
Switching The Ikôn Off
Important: Keep in mind that turning off the Ikôn does not result in a complete reboot;
To switch off the Ikôn, press and hold the Power button for five seconds. The Shutdown
dialog box (Figure 2.4 on page 13) will appear for you to choose whether you want to
Shutdown or Suspend.
12
Ikôn Rugged PDA (Windows CE 5.0) User Manual
options:
The battery capacity may be too low (capacity < 100mAh), it may be over-
heated (>60C°), a non-Psion Teklogix battery may be installed, or the
battery may have fallen below the configured Suspend Threshold. See
"Suspend Threshold And Estimated Battery Backup" on page 102
for details.
If you provide AC power to an Ikôn, and either the battery capacity is too
low or the battery is overheated, a yellow LED will flash and the unit will
not switch on. To switch on the PDA, you will need to replace the over-
heated battery or, in the case of a depleted battery, wait for the capacity to
reach an acceptable level.
However, if you supply AC power to an Ikôn with a battery that falls below
the configured Suspend Threshold, the PDA will switch on.
rather, the unit enters a power-saving, "suspend" state. When the unit is
turned on from suspend state, operation resumes within a few seconds.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents