Husqvarna Automower 105 Operator's Manual page 36

Message Cause
Outside working area The boundary wire connections to the charg-
ing station are crossed.
The boundary wire is too close to the edge of
the working area.
The working area slopes too much.
The boundary wire is laid in the wrong direc-
tion around an island.
Disturbances from metal objects (fences, re-
inforcement steel) or buried cables close by.
The robotic lawnmower finds it hard to distin-
guish the signal from another robotic lawn-
mower installation close by.
Low battery / Empty
The robotic lawnmower cannot find the charg-
battery
ing station.
The guide wire is broken or not connected.
The battery is spent.
The charging station's antenna is defective.
Wrong PIN
Wrong PIN code has been entered. Five at-
tempts are permitted, and the keypad is then
blocked for five minutes.
Wheel motor overloa-
The robotic lawnmower has got caught in
ded,right
something.
Wheel motor overloa-
ded, left
No drive The robotic lawnmower has got caught in
something.
The working area includes a steep slope.
The guide wire is not laid at an angle on a
slope.
Charging station
The contact between the charging strips and
blocked
contact strips may be poor and the robotic
lawnmower has made a number of attempts
to charge.
An object is obstructing the robotic lawnmow-
er.
The charging station is tilted or bent.
36 - Troubleshooting
Action
Check that the boundary wire is connected
correctly.
Check that the boundary wire has been laid
according to the instructions in
on page 13 .
Try moving the boundary wire.
Place the robotic lawnmower in the charging
station and generate a new loop signal via
Security -> New loop signal .
Check that the charging station and the guide
wire are installed in accordance with the in-
Installation on page 10 .
structions in
Check that the indicator lamp in the charging
station flashes yellow. See the solution in,
dicator lamp in the charging station on page
38 .
Replace the battery. See
Check if the indicator lamp in the charging
Indicator lamp in the
station flashes red. See
charging station on page 38 .
Enter the correct PIN code. Contact your lo-
cal Husqvarna representative if you forget the
PIN code.
Free the robotic lawnmower and rectify the
reason for the lack of drive. If it is due to wet
grass, wait until the lawn has dried before us-
ing the robotic lawnmower.
Free the robotic lawnmower and rectify the
reason for the lack of drive. If it is due to wet
grass, wait until the lawn has dried before us-
ing the robotic lawnmower.
Maximum guaranteed slope is 25%. Steeper
slopes should be isolated. See
page 16 .
If the guide wire is laid on a slope, it must be
laid at an angle across the slope. See
lation of the guide wire on page 18
Put the robotic lawnmower in the charging
station and check that the charging strips and
contact strips make good contact.
Remove the object.
Confirm that the charging station is placed on
a fully flat and horizontal ground. The charg-
ing station must not be tilted or bent.
Boundary wire
In-
Battery on page 34 .
Slopes on
Instal-
136 - 003 -