Husqvarna Automower 105 Operator's Manual page 14

• About 20 cm of extra wire is available to which the
guide wire will be connected later. See
boundary wire on page 16 .
The illustration below shows how the boundary wire
must be laid around the working area and around
obstacles. Use the supplied measurement gauge to
obtain the correct distance. See
page 5 .
0 cm
20 cm / 8"
3.5.2 Working area boundaries
Depending on what the working area is adjacent to, the
boundary wire must be laid at different distances from
obstacles.
If a high obstacle (5 cm or more), for example a wall or
fence, borders the working area, the boundary wire
should be laid 30 cm from the obstacle. This will prevent
the robotic lawnmower from colliding with the obstacle
and reduce body wear. About 20 cm of the lawn around
the fixed obstacle will not be mown.
14 - Installation
Laying the
Product overview on
5 cm / 2"
30 cm / 12"
If the working area borders a small ditch, a flower bed or
a small elevation, for example a low kerbstone (3-5 cm),
the boundary wire should be laid 20 cm inside the
working area. This prevents the wheels from driving into
the ditch or up onto the kerbstone which might be lead
to excessive wear on the robotic lawnmower. About 12
cm of the lawn along the ditch/kerbstone will not be
mown.
If the working area borders on a paving stone path or
similar that is level with the lawn (+/- 1 cm), it is possible
to allow the robotic lawnmower to run a little over the
path. The boundary wire should then be laid 5 cm from
the edge of the path. All the grass along the side of the
paving stone path will be cut.
10 cm / 4"
When the working area is divided by a paving stone path
that is level with the lawn, it is possible to allow the
robotic lawnmower to run over the path. It can be an
advantage to lay the boundary wire under the paving
stones. The boundary wire can also be laid in the joint
between the paving stones. Ensure that the tiles are in
level with the lawn to avoid excessive wear on the
robotic lawnmower.
30 cm / 12"
> 5 cm /2"
20 cm / 8"
1-5 cm / 0.4-2"
max 1 cm / 0.4"
136 - 003 -