Table of Contents
Advertisement
VARIO
SELECT ANNOUNCE
REPEAT10SEC.
NEXT ANNOUNCE
VARIO
AUTO
TRANSMITTER
RECEIVER
GPS
Transmitter
SELECT ANNOUNCE
REPEAT10SEC.
NEXT ANNOUNCE
VARIO
AUTO
TRANSMITTER
RECEIVER
GPS
TRANSMITTER VOLT
BATTERY TIME:
STOPWATCH
:
FLIGHT TIMER:
RECEIVER
"Sensors"
S1002.PRO_mz12PRO_Teil2_V1sh
As long as the switches assigned to the line "REPEAT" and "TRIGGER"
are switched on, the selected announces will be repeated in the
adjusted interval.
In order to be able to start outputting Vario tones via the headphone
3
jack, this line must be assigned a switch.
1
–––
If there are several Vario sensors in the model, for example a General
Electric and a GPS module, the Vario sensor, which determines the
output of the varios, can be selected:
The following selections are available: VARIO, GAM, EAM, GPS so as
AUTO. (Following this sequence, the first of the sensors connected
to the receiver is selected as the "main" in the "Auto" position.)
After selecting the desired menu line, pressing the selection keys
3
and the SET key opens the selected submenu.
1
4
Programming step-by-step
1. Select the desired line using the selection keys.
2. Push the ENT button to switch between
3. Proceed in the same way with the remaining lines.
The receiver voice triggers are selected as described above.
The names of sensors are only displayed line-by-line if the sensors
connected to the receiver are detected automatically when the RC
system is switched on.
Three corresponding voice triggers are selected as described above.
(ON) and
(OFF).
99 / 116
Advertisement
Table of Contents
