Table of Contents
Advertisement
88 / 116
The default setting "00" must be selected or left if no mixer is to be
set.
TRAVEL–/+
With the settings of these two lines, the percentage of mixing is
specified in relation to the MASTER signal separately for both direc-
tions.
Programming step-by-step
1. Push the ENT key.
2. Set the desired mixer 1 ... 5 through the selection keys.
‖ The following settings in this display only relate to the mixers
selected in the "MIXER" line:
3. Use the selection keys to move to the MASTER CH line.
4. Push the ENT key.
5. Set the desired MASTER CHANNEL (source channel) through the
selection keys.
6. Push the ENT key.
7. Set the desired SLAVE CHANNEL (target channel) through the
selection keys.
8. Push the ENT key.
9. Use the selection keys to move to the S-TRAVEL- and/or S-TRAVEL+
line.
10. Push the ENT key.
11. Use the selection keys to set the desired value.
12. Press the ENT key to complete the operation.
RX WING MIXER TAIL TYPE
Note
The types of tail described below are also available in the line "Tail"
of the sub-menu "Model type" and should preferably be specified
there. In this case, the default "NORMAL" must always be left in the
line "TAIL TYPE".
NORMAL
This setting corresponds to the classic airplane type with a rear tail
and separate rudder and elevator. No mixing function is required for
this model type.
(level of mixing in %)
(tail type)
S1002.PRO_mz12PRO_Teil2_V1sh
Advertisement
Table of Contents
