Race Timer - GRAUPNER mz-12 PRO Manual

Race Timer

M.Stop –100% +150%
Min.Thr. min +5%
Timers 4:00
Race Timer
STO
5.1V
M -0 1 Sta. + 0 :05
Flight
4. 0V
K78
0 :5 2 h
NR
Start switch
Countdown 5sec
Random start no
Start switch
Countdown 5sec
Random start no
38 / 116
3. Push the ENT key.
4. Use the selection keys to move to the seconds field.
5. Push the ENT key.
6. Use the selection buttons to set the desired number of seconds.
7. Push the ENT key.
8. Use the selection keys to switch to the switch field.
9. Push the ENT key.
10. Assigning the desired switch.
With this option the start of races can be trained:
1
When the start switch is pressed, the voice counts down a selectable
yes
---
period backwards to "0". A timer automatically starts when zero is
=>
reached and stops the elapsed time when the throttle / pitch control
stick is actuated for the first time. This is shown in the display instead
of the stopwatch until either the start switch is reset or the transmit-
ter is switched off.
0 :0 0 Two different start-up procedures are available:
• Random start "No"
5.5V
The announcement will run smoothly until 0 seconds.
• Random start "Yes"
–––
The time between announcement 1 and 0 is different.
Programming step-by-step
1. Push the ENT key to change to the setting page.
2. Assigning the desired start switch.
–––
3. Use the lower selection key to change to the "Countdown" line if
the default value is to be changed.
4. Push the ENT key.
5. Then use the selection keys to set a value between 10 and 0.
6. Push the ENT key.
7. Use the lower selection key to change to the "Random start" line,
if necessary.
8. Push the ENT key.
9. Use the selection keys to select "yes" or "no".
10. Push the ENT key.
11. Use the ESC key to leave the setting menu.
S1002.PRO_mz12PRO_Teil2_V1sh