Table of Contents
Advertisement
RX CURVE
V3.70
CURVE1 CH
:
02
TYPE :
B
CURVE2 CH
:
05
TYPE :
B
CURVE3 CH
:
04
TYPE :
B
5CH FUNCTION:SERVO
Servo
Sensor
RX CURVE
V3.70
CURVE1 CH
:
02
TYPE :
B
CURVE2 CH
:
05
TYPE :
B
CURVE3 CH
:
04
TYPE :
B
5CH
FUNCTION:SERVO
90 / 116
CURVE 1, 2 or 3 CH
Select the desired control channel (INPUT CH).
The following setting in TYPE only affects the selected channel.
TYPE
Select the desired control curve:
A EXPO = -100 % and DUAL RATE = 125 %
The servo reacts strongly to control stick movement around the
neutral position. The curve becomes flatter as the rudder deflec-
tion increases to about 125% of the servo travel.
B Linear setting.
The Servo follows the control stick travel in a linear manner in
case of not changed servo travel.
C EXPO = +100 % and DUAL RATE = 70 %
The servo reacts weakly to control stick movement around the
neutral position. The curve becomes steeper as the rudder
deflection reduces to about 70% of the servo travel.
5CH FUNCTION: "SERVO" or "SENSOR"
With certain receivers, a certain servo connection is designed to be
switchable instead of an independent telemetry connection. Thus,
for example, not only the adapter cable (No. 7168.6S) for updating
the receiver but also a telemetry sensor can be connected to the
receiver GR-12L on the servo connection 5, which is marked with an
additional "T".
In order for the connected device to be correctly identified by the
OR
receiver, servo connection 5 needs to be switched from "SERVO" to
"SENSOR" and vice versa.
Programming step-by-step
1. Use the lower selection key to move the symbol " " on the left
margin in front of the lowest line.
2. Push the ENT key.
The selection field is displayed inverted.
3. Use one of the selection buttons to select the desired setting, for
example "SENSOR".
4. Push the ENT key.
5. Push with correspondingly frequency the ESC key to return to the
basic display of the transmitter.
S1002.PRO_mz12PRO_Teil2_V1sh
Advertisement
Table of Contents
